RAM 1500 — ENGINE BREAK-IN RECOMMENDATIONS — GASOLINE ENGINE

STARTING AND OPERATING 137 Do Not Operate The Engine With Failed Parts The engine block heater warms engine coolant and permits quicker starts in cold weather. Connect the heater cord to a ground-fault interrupter protected 110–115 Volt AC electrical outlet with a grounded, three-wire extension cord. ENGINE BREAK-IN RECOMMENDATIONS — GASOLINE ENGINE All engine failures give some warning before the parts fail. Some important observations are: A long break-in period is not required for the engine and drivetrain (transmission and axle) in your vehicle.

Engine misfiring or vibrating severely Sudden loss of power For diesel engines, its use is recommended for environments that routinely fall below -10°F (-23°C). It should be used when the vehicle has not been running for long periods of time and should be plugged in two hours prior to start. Its use is required for cold starts with temperatures under -20°F (-28°C). Drive moderately during the first 300­miles (500­km). After the initial 60­miles (100­km), speeds up to 50 or 55­mph (80 or 90­km/h) are desirable.

Unusual engine noises Fuel, oil or coolant leaks Sudden change, outside the normal operating range, in the engine operating temperature 4 Excessive smoke To ensure reliable starting at these temperatures, use of an externally powered electric engine block heater (available from an authorized dealer) is recommended. While cruising, brief full-throttle acceleration within the limits of local traffic laws contributes to a good break-in. Wide-open throttle acceleration in low gear can be detrimental and should be avoided.

Oil pressure drop ENGINE BLOCK HEATER — IF EQUIPPED The engine block heater cord is routed under the hood on the passenger side of the vehicle next to the engine coolant reservoir. The engine oil installed in the engine at the factory is a high-quality energy conserving type lubricant. Oil changes should be consistent with anticipated climate conditions under which vehicle operations will occur. For the recommended viscosity and quality grades Ъ ­page­438. WARNING!­ Remember to disconnect the engine block heater cord before driving. Damage to the 110-115 Volt electrical cord could cause electrocution.

CAUTION!­ Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result. NOTE: A new engine may consume some oil during its first few thousand miles (kilometers) of operation. This should be considered a normal part of the break-in Engine Block Heater Cord Location