RAM 1500 — Electric Park Brake (EPB)

138 STARTING AND OPERATING and not interpreted as a problem. Please check your oil level with the engine oil indicator often during the break in period. Add oil as required. ENGINE BREAK-IN RECOMMENDATIONS — DIESEL ENGINE will occur. For the recommended viscosity and quality grades Ъ ­page­438. NOTE: NON-DETERGENT OR STRAIGHT MINERAL OILS MUST NEVER BE USED. PARKING BRAKE The diesel engine does not require a break-in period due to its construction. Normal operation is allowed, providing the following recommendations are followed:

E LECTRIC P ARK B RAKE (EPB) Your vehicle is equipped with an EPB that offers simple operation, and some additional features that make the parking brake more convenient and useful. Electric Park Brake Switch Warm up the engine before placing it under load. To apply the parking brake manually, pull up on the switch momentarily. You may hear a slight sound from the back of the vehicle while the parking brake engages. Once the park brake is fully engaged, the BRAKE telltale light in the instrument cluster and an indicator on the switch will illuminate. If your foot is on the brake pedal while you apply the parking brake, you may notice a small amount of brake pedal movement.

The parking brake can be applied even when the ignition switch is OFF but the BRAKE telltale light will not illuminate, however, it can only be released when the ignition is in the ON/RUN mode. Do not operate the engine at idle for prolonged periods. The parking brake is primarily intended to prevent the vehicle from rolling while parked. Before leaving the vehicle, make sure that the parking brake is applied. Also, be certain to leave the transmission in PARK. Observe vehicle oil pressure and temperature indicators. Check the coolant and oil levels frequently. Vary throttle position at highway speeds when carrying or towing significant weight. You can engage the parking brake in two ways:

Manually, by applying the parking brake switch. NOTE: Light duty operation such as light trailer towing or no load operation will extend the time before the engine is at full efficiency. Reduced fuel economy and power may be seen at this time. The engine oil installed in the engine at the factory is a high-quality energy conserving type lubricant. Oil changes should be consistent with anticipated climate conditions under which vehicle operations Automatically, by enabling the Auto Park Brake feature in the Customer Programmable Features section of the Uconnect settings. The parking brake switch is located on the instrument panel to the left of the steering wheel (below the headlamp switch).

NOTE: The EPB fault light will illuminate if the EPB switch is held for longer than 20 seconds in either the released or applied position. The light will extin­ guish upon releasing the switch.