RAM 1500 — Electronic Range Select (ERS) Operation

STARTING AND OPERATING 145 Transmission Limp Home Mode 4. Wait approximately 30 seconds. instrument cluster, and set that gear as the top available gear. Once in ERS mode, tapping the - or + button will change the top available gear. Transmission function is monitored electronically for abnormal conditions. If a condition is detected that could result in transmission damage, Transmission Limp Home Mode is activated. In this mode, the transmission may operate only in certain gears, or may not shift at all. Vehicle performance may be severely degraded and the engine may stall. In some situations, the transmission may not re-engage if the engine is turned off and restarted.

The Malfunction Indicator Light (MIL) may be illuminated. A message in the instrument cluster will inform the driver of the more serious conditions, and indicate what actions may be necessary. 6. Shift into the desired gear range. If the problem is no longer detected, the transmission will return to normal operation. 5. Restart the engine. NOTE: Even if the transmission can be reset, we recommend that you visit an authorized dealer at your earliest possible convenience. An authorized dealer has diagnostic equipment to assess the condition of your transmission. If the transmission cannot be reset, an authorized dealer service is required.

Electronic Range Select (ERS) Operation 4 Electronic Range Select (ERS) In the event of a momentary problem, the transmission can be reset to regain all forward gears by performing the following steps: The ERS shift control allows the driver to limit the highest available gear when the transmission is in DRIVE and ERS mode is not active. For example, if you set the transmission gear limit to FOURTH gear, the transmission will not shift above FOURTH gear (except to prevent engine overspeed), but will shift through the lower gears normally. 1 — Shift Up (+) 2 — Shift Down (–) NOTE:

In cases where the instrument cluster message indicates the transmission may not re-engage after engine shutdown, perform this procedure only in a desired location (preferably, at an authorized dealer). 1. Stop the vehicle. To exit ERS mode, simply push and hold the + button until the gear limit display disappears from the instrument cluster. You can switch between DRIVE and ERS mode at any vehicle speed. When the transmission gear selector is in DRIVE, the transmission will operate automatically, shifting between all available gears.

Tapping the - button (on the steering wheel) will activate ERS mode, display the current gear in the WARNING!­ Do not downshift for additional engine braking on a slippery surface. The drive wheels could lose their grip and the vehicle could skid, causing a collision or personal injury. 2. Shift the transmission into PARK, if possible. If not, shift the transmission to NEUTRAL. 3. Push and hold the ignition switch until the engine turns off.