RAM 1500 — Five-Position Electronically Shifted Transfer Case — If Equipped

148 STARTING AND OPERATING WARNING!­ Shifting Procedure Always engage the parking brake when powering down the vehicle if the SERV 4WD Warning Light is illuminated. Not engaging the parking brake may allow the vehicle to roll which may cause personal injury or death. If any of the requirements to select a new transfer case position have not been met, then the transfer case will not shift. The position indi­ cator light for the previous position will remain on and the newly selected position indicator light will continue to flash until all the require­ ments for the selected position have been met. NOTE: Do not attempt to make a shift while only the front or rear wheels are spinning.

This could cause damage to driveline components. When operating your vehicle in 4WD LOW, the engine speed is approximately three times that of the 2WD or 4WD HIGH positions at a given road speed. Take care not to overspeed the engine and do not exceed 25­mph (40­km/h). If all the requirements to select a new transfer case position have been met, then the current position indicator light will turn off and the selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the position indicator light for the selected position will stop flashing and remain on.

F IVE -P OSITION E LECTRONICALLY S HIFTED T RANSFER C ASE I F E QUIPPED Five-Position/On-Demand Transfer Case This electronically shifted transfer case provides five mode positions: Two-Wheel Drive High Range (2WD) — This range is for normal street and highway driving on dry hard surfaced roads. Driving the vehicle in 2WD will have greater fuel economy benefits as the front axle is not engaged in 2WD. Proper operation of four-wheel drive vehicles depends on tires of equal size, type and circumference on each wheel. Any difference in tire size can cause damage to the drivetrain.

Four-Wheel Drive Automatic High Range (4WD AUTO) — This range sends power to the front wheels automatically when the vehicle senses a loss of traction. This range may be used during varying road conditions. This is an electronic shift transfer case and is operated by the 4WD Control Switch (Transfer Case Switch), which is located on the instrument panel. Because four-wheel drive provides improved traction, there is a tendency to exceed safe turning and stopping speeds. Do not go faster than road conditions permit.

Four-Wheel Drive High Range (4WD HIGH) — This range provides torque to the front drive­ shaft (engages four-wheel drive) which allows front and rear wheels to spin at the same speed. This provides additional traction for loose or slippery road surfaces only.