STARTING AND OPERATING 147 range provides additional traction and maximum pulling power for loose or slippery road surfaces only. Do not exceed 25mph (40km/h) in this range. NOTE: If the transfer case does not shift into the desired position, one or more of the following events may occur: The 4WD HIGH and 4WD LOW positions are designed for loose, slippery road surfaces only. Driving in the 4WD HIGH and 4WD LOW posi tions on dry, hard surfaced roads may cause increased tire wear and damage to the driveline components. N (Neutral) — This range disengages both the front and rear driveshafts from the powertrain. To be used for flat towing behind another vehicle Ъ page210. 1.
The indicator light for the current position will remain on. 2. The newly selected position indicator light will continue to flash. The transfer case N (Neutral) button is located in the center of the 4WD Control Switch and is pushed by using a ballpoint pen or similar object. The transfer case N (Neutral) position is to be used for recreational towing only Ъ page210. 3. If the transfer case will not shift, a message will appear on the cluster stating the 4WD shift has canceled. You or others could be injured or killed if you leave the vehicle unattended with the transfer case in the N (Neutral) position without first fully engaging the parking brake.
The transfer case N (Neutral) position disengages both the front and rear drive shaft from the powertrain, and will allow the vehicle to roll, even if the transmission is in PARK. The parking brake should always be applied when the driver is not in the vehicle. WARNING! 4 NOTE: Before retrying a selection, make certain that all the necessary requirements for selecting a new transfer case position have been met. To retry the selection, push the current position, wait five seconds, and retry selection. The SERV 4WD Warning Light monitors the electronic shift four-wheel drive system.
If this light remains on after engine start up or illuminates during driving, it means that the four-wheel drive system is not functioning properly and that service is required. Transfer Case Position Indicator Lights The Transfer Case Position Indicator Lights (4WD HIGH and 4WD LOW) are located in the instrument cluster and indicate the current and desired transfer case selection. When you select a different transfer case position, the indicator lights will do the following: The transmission may not engage PARK if the vehicle is moving.
Always bring the vehicle to a complete stop before shifting to PARK, and verify that the transmission gear position indi cator solidly indicates PARK (P) without blinking. Ensure that the vehicle is completely stopped, and the PARK position is properly indicated, before exiting the vehicle. 1. The current position indicator light will turn off. 2. The selected position indicator light will flash until the transfer case completes the shift. 3. When the shift is complete, the indicator light for the selected position will stop flashing and remain on.