RAM 1500 — Description

150 STARTING AND OPERATING during driving, it means that the four-wheel drive system is not functioning properly and that service is required. Shifting Procedure If any of the requirements to select a new transfer case position have not been met, then the transfer case will not shift. The position indi­ cator light for the previous position will remain on and the newly selected position indicator light will continue to flash until all the require­ ments for the selected position have been met. WARNING!­ Always engage the parking brake when powering down the vehicle if the SERV 4WD Warning Light is illuminated.

Not engaging the parking brake may allow the vehicle to roll which may cause personal injury or death. If all the requirements to select a new transfer case position have been met, then the current position indicator light will turn off and the selected position indicator light will flash until the transfer case completes the shift. When the shift is complete, the position indicator light for the selected position will stop flashing and remain on. ACTIVE-LEVEL FOUR CORNER AIR SUSPENSION SYSTEM — IF EQUIPPED Air Suspension Switch NOTE: Do not attempt to make a shift while only the front or rear wheels are spinning. This could cause damage to driveline components.

When operating your vehicle in 4WD LOW, the engine speed is approximately three times that of the 2WD, 4WD AUTO or 4WD HIGH positions at a given road speed. Take care not to overspeed the engine and do not exceed 25­mph (40­km/h). 1 — Off-Road 2 Indicator (Customer Selectable) 2 — Off-Road 1 Indicator (Customer Selectable) 3 — Normal Ride Height Indicator (Customer Selectable) 4 — Aero Mode Indicator (Customer Selectable) 5 — Entry/Exit Mode Indicator (Customer Selectable) Proper operation of four-wheel drive vehicles depends on tires of equal size, type and circumference on each wheel. Any difference in tire size can cause damage to the drivetrain.

D ESCRIPTION Normal Ride Height (NRH) – This is the standard position of the suspension and is meant for normal driving. The air suspension system provides full time load leveling capability along with the benefit of being able to adjust vehicle height by using the toggle switch. Because four-wheel drive provides improved traction, there is a tendency to exceed safe turning and stopping speeds. Do not go faster than road conditions permit. Off-Road 1 (OR1) (Raises the vehicle approxi­ mately 1­inch (26­mm)) – This position should be the primary position for all off-road driving until Off-Road 2 (OR2) is needed. A smoother and more comfortable ride will result.

To enter OR1, push the height selector switch up once from the NRH position while the vehicle speed is