RAM 1500 — Description

STARTING AND OPERATING 151 below 35­mph (56­km/h). When in the OR1 position, if the vehicle speed remains between 40­mph (64­km/h) and 50­mph (80­km/h) for greater than 20 seconds or if the vehicle speed exceeds 50­mph (80­km/h), the vehicle will be automatically lowered to NRH. Off-Road 1­may not be available due to vehicle payload, an instrument cluster message will be displayed when this occurs Ъ ­page­104. Aero Mode (Lowers the vehicle approximately 0.6­inch [15­mm]) – This position provides improved aerodynamics by lowering the vehicle.

The vehicle will automatically enter Aero Mode when the vehicle speed remains between 62­mph (100­km/h) and 66­mph (106­km/h) for greater than 20 seconds or if the vehicle speed exceeds 66­mph (106­km/h). The vehicle will return to NRH from Aero Mode if the vehicle speed remains between 30­mph (48­km/h) and 35­mph (56­km/h) for greater than 20 seconds or if the vehicle speed falls below 30­mph (48­km/h). NOTE: Automatic Aero Mode may be disabled through vehicle settings in the instrument cluster display Ъ ­page­104 or through your Uconnect Radio (if equipped) Ъ ­page­216.

Entry/Exit Mode (Lowers the vehicle approxi­ mately 2­inches (51­mm)) – This position lowers the vehicle for easier passenger entry and exit as well as lowering the rear of the vehicle for easier loading and unloading of cargo. To enter Entry/ Exit Mode, push the height selector switch down once from the NRH while the vehicle speed is below 33­mph (53­km/h). Once the vehicle speed goes below 15­mph (24­km/h) the vehicle height will begin to lower. If the vehicle speed remains between 15­mph (24­km/h) and 25­mph (40­km/h) for greater than 60 seconds, or the vehicle speed exceeds 25­mph (40­km/h) the Entry/Exit change will be canceled.

To return to Normal Height Mode, push the height selector switch up once while in Entry/Exit or drive the vehicle over 15­mph (24­km/h). Entry/Exit mode may not be available due to vehicle payload, an instrument cluster message will be displayed when this occurs Ъ ­page­104. Off-Road 2 (OR2) (Raises the vehicle approxi­ mately 2­inches (51­mm)) – This position is intended for off-roading use only where maximum ground clearance is required. To enter OR2, push the height selector switch up twice from the NRH position or once from the OR1 position while vehicle speed is below 20­mph (32­km/h).

While in OR2, if the vehicle speed exceeds 25­mph (40­km/h) the vehicle height will be automatically lowered to OR1. Off-Road 2­may not be available due to vehicle payload, an instrument cluster message will be displayed when this occurs Ъ ­page­104. 4 NOTE: The vehicle will automatically enter Aero Mode when the vehicle speed remains between 62­mph (100­km/h) and 66­mph (106­km/h) for greater than 20 seconds or if the vehicle speed exceeds 66­mph (106­km/h). Speed thresholds for raising the vehicle only apply if Automatic Aero Mode is enabled.

CAUTION!­ If the vehicle is in Off-Road 1 or Off-Road 2 setting, be aware of your surroundings, you may not have the clearance required for certain areas and vehicle damage may occur. To enter Aero Mode manually push the height selector switch down once from NRH at any vehicle speed. To return to NRH push the height selector switch up once while vehicle speed is less than 56­mph (90­km/h). NOTE: Entry/Exit mode may be achieved using your key fob for easier entry/loading Ъ ­page­17.