RAM 1500 — Operation

STARTING AND OPERATING 153 Wheel Alignment Mode O PERATION maximum position of OR2 or the highest position allowed based on current conditions (i.e., vehicle speed, etc.). Before performing a wheel alignment, this mode must be enabled Ъ ­page­216. Protection Strategy Pushing the height selector down once will move the suspension one position lower from the current level, assuming all conditions are met (i.e., ignition in ON/RUN position, engine running, doors closed, speed below threshold, etc.).

The height selector switch can be pushed down multiple times, each push will lower the requested level by one position down to a minimum of Entry/Exit Mode or the lowest position allowed based on current conditions (i.e., vehicle speed, etc.). In order to “protect” the air suspension system, the vehicle will disable load leveling as required (suspension overloaded, battery charge low, etc.). Load leveling will automatically resume as soon as system operation requirements are met. See an authorized dealer if system does not resume. 4 NOTE: For towing with air suspension Ъ ­page­196.

I NSTRUMENT C LUSTER D ISPLAY M ESSAGES Air Suspension Switch The indicator lamps 1 through 5 will illuminate to show the current position of the vehicle. Flashing indicator lamps will show a position which the system is working to achieve. When raising, if multiple indicator lamps are flashing, the highest flashing indicator lamp is the position the system is working to achieve. When lowering, if multiple indicators are flashing, the lowest solid indicator lamp is the position the system is working to achieve. Automatic height changes will occur based on vehicle speed and the current vehicle height.

The indicator lamps and instrument cluster display messages will operate the same for automatic changes and user requested changes. When the appropriate conditions exist, a message will appear in the instrument cluster display Ъ ­page­104. Off-Road 2 (OR2) – Indicator lamps 5, 4, 3, An audible chime will be heard whenever a system error has been detected. 2 and 1 will be illuminated when the vehicle is in OR2. See an authorized dealer for system service if normal operation does not resume. Off-Road 1 (OR1) – Indicator lamps 5, 4, 3 and 2 will be illuminated when the vehicle is in OR1.

Pushing the height selector up once will move the suspension one position higher from the current position, assuming all conditions are met (i.e., ignition in ON/RUN position, engine running, speed below threshold, etc.). The height selector switch can be pushed up multiple times, each push will raise the requested level by one position up to a Normal Ride Height (NRH) – Indicator lamps 5, 4 and 3 will be illuminated when the vehicle is in this position. Aero Mode – Indicator lamps 5 and 4 will be illu­ minated when the vehicle is in this position.