RAM 1500 — Description

STARTING AND OPERATING 155 (106­km/h) for greater than 20 seconds or if the vehicle speed exceeds 66­mph (106­km/h). vehicle over 15­mph (24­km/h). Entry/Exit mode may not be available due to vehicle payload, an instrument cluster display message will be shown when this occurs Ъ ­page­104. To assist with changing a spare tire, the air suspension system has a feature which allows the automatic leveling to be disabled Ъ ­page­216. Speed thresholds for raising the vehicle only apply if Automatic Aero Mode is enabled. NOTE: To enter Aero Mode manually push the height selector switch down once from NRH at any vehicle speed.

To return to NRH push the height selector switch up once while vehicle speed is less than 56­mph (90­km/h). When in Entry/Exit mode, be aware of your surroundings, you may not have the clearance required for certain areas and vehicle damage may occur. CAUTION!­ Default Ride Height: Select Aero Height or Normal Ride Height as the default for all vehicle speeds and operation. This is the selected height that the suspension will level for speed changes (e.g. raising from Entry/Exit Height at speed, lowering from Off Road Height at speed, etc.). 4 Automatic Aero Mode may be disabled through vehicle settings on your Uconnect Radio.

The system requires that the ignition be in the ON/ RUN position or the engine running for all user requested changes. When lowering the vehicle, all of the doors must be closed. If a door is opened at any time while the vehicle is lowering, the change will not be completed until the open door(s) is closed. Default ride height can be changed by manually adjusting the ride height switch to Normal Ride Height or Aero Ride Height and stay in the selected height for 2.5 seconds. It will be stored as the default ride height and the height will be maintained until a new default ride height is selected.

Entry/Exit Mode (Lowers the vehicle approxi­ mately 3­inches (73­mm)) – This position lowers the vehicle for easier passenger entry and exit as well as lowering the rear of the vehicle for easier loading and unloading of cargo. To enter Entry/ Exit Mode, push the height selector switch down twice from the NRH while the vehicle speed is below 33­mph (53­km/h). Once the vehicle speed goes below 15­mph (24­km/h) the vehicle height will begin to lower. If the vehicle speed remains between 15­mph (24­km/h) and 25­mph (40­km/h) for greater than 60 seconds, or the vehicle speed exceeds 25­mph (40­km/h) the Entry/Exit change will be canceled.

To return to Normal Height Mode, push the height selector switch up twice while in Entry/Exit or drive the This system uses a lifting and lowering pattern which keeps the headlights from incorrectly shining into oncoming traffic. When raising the vehicle, the rear of the vehicle will move up first and then the front. When lowering the vehicle, the front will move down first and then the rear. If equipped with a touchscreen radio, all enabling/ disabling of air suspension features must be done through the radio Ъ ­page­216. After the engine is turned off, it may be noticed that the air suspension system operates briefly; this is normal.

The system is correcting the position of the vehicle to ensure a proper appearance. The air suspension system uses a high pressure volume of air to operate the system. To avoid personal injury or damage to the system, see an authorized dealer for service. WARNING!­