156 STARTING AND OPERATING A IR S USPENSION M ODES NOTE: For towing with air suspension Ъ page196. I NSTRUMENT C LUSTER D ISPLAY M ESSAGES The indicator lamps 1 through 4 will illuminate to show the current position of the vehicle. Flashing indicator lamps will show a position which the system is working to achieve. When raising or lowering, the flashing indicator lamp is the position the system is working to achieve. The air suspension system has multiple modes to protect the system in unique situations: AERO Mode To improve aerodynamics, the air suspension system has a feature which will put the vehicle into AERO height automatically Ъ page104.
When the appropriate conditions exist, a message will appear in the instrument cluster display Ъ page104. Pushing the height selector switch up once will move the suspension one position higher from the current position, assuming all conditions are met (i.e., key in ON/RUN position, engine running, speed below threshold, etc.). The height selector switch can be pushed up multiple times, each push will raise the requested level by one position up to a maximum position of OR or the highest position allowed based on current conditions (i.e., vehicle speed, etc.). Tire Jack Mode An audible chime will be heard whenever a system error has been detected.
To assist with changing a tire, the air suspension system has a feature which allows the automatic leveling to be disabled Ъ page216. See an authorized dealer for system service if normal operation does not resume. O PERATION For towing your vehicle with four wheels off the road, the air suspension system has a feature which will put the vehicle into Entry/Exit height and disable the automatic load leveling system Ъ page216. Transport Mode Pushing the height selector switch down once will move the suspension one position lower from the current level, assuming all conditions are met (i.e., key in ON/RUN position, engine running, doors closed, speed below threshold, etc.).
The height selector switch can be pushed down multiple times, each push will lower the requested level by one position down to a minimum of Entry/Exit Mode or the lowest position allowed based on current conditions (i.e., vehicle speed, etc.). Wheel Alignment Mode Before performing a wheel alignment, this mode must be enabled Ъ page216. Protection Strategy In order to “protect” the air suspension system, the vehicle will disable load leveling as required (suspension overloaded, battery charge low, etc.). Load leveling will automatically resume as soon as system operation requirements are met. See an authorized dealer if system does not resume. Air Suspension Switch