STARTING AND OPERATING 161 Only one Cruise Control feature can operate at a time. For example, if Fixed Speed Cruise Control is enabled, Adaptive Cruise Control will be unavailable, and vice versa. C RUISE C ONTROL WARNING! To Set A Desired Speed Cruise Control can be dangerous where the system cannot maintain a constant speed. Your vehicle could go too fast for the conditions, and you could lose control and have an accident. Do not use Cruise Control in heavy traffic or on roads that are winding, icy, snow-covered or slippery. Turn the Cruise Control on. When the vehicle has reached the desired speed, push the SET (+) or SET (-) button and release.
Release the accelerator and the vehicle will operate at the selected speed. When engaged, the Cruise Control takes over accelerator operations at speeds greater than 20mph (32km/h). NOTE: The vehicle should be traveling at a steady speed and on level ground before pushing the SET (+) or SET (-) button. To Vary The Speed Setting The Cruise Control buttons are located on the right side of the steering wheel. To Activate 4 Push the on/off button to activate the Cruise Control. The cruise indicator light in the instrument cluster display will illuminate. To turn the system off, push the on/off button a second time. The cruise indicator light will turn off.
The system should be turned off when not in use. To Increase Or Decrease The Set Speed When the Cruise Control is set, you can increase speed by pushing the SET (+) button, or decrease speed by pushing the SET (-) button. U.S. Speed (mph) WARNING! Pushing the SET (+), or SET (-) button once will result in a 1mph speed adjustment. Each subsequent tap of the button results in an adjustment of 1mph. Leaving the Cruise Control system on when not in use is dangerous. You could accidentally set the system or cause it to go faster than you want. You could lose control and have an accident. Always ensure the system is off when you are not using it.
Cruise Control Buttons If the button is continually pushed, the set speed will continue to adjust until the button is released, then the new set speed will be estab lished. 1 — SET (+)/Accel 2 — CANC/Cancel 3 — SET (-)/Decel 4 — On/Off 5 — RES/Resume