RAM 1500 — Adaptive Cruise Control (ACC)

162 STARTING AND OPERATING Metric Speed (km/h) WARNING!­ Gear selector is moved out of DRIVE Pushing the SET (+), or SET (-) button once will result in a 1­km/h speed adjustment. Each subsequent tap of the button results in an adjustment of 1­km/h. Cruise Control can be dangerous where the system cannot maintain a constant speed. Your vehicle could go too fast for the conditions, and you could lose control and have an accident. Do not use Cruise Control in heavy traffic or on roads that are winding, icy, snow-covered or slippery. Engine overspeed occurs Pushing the on/off button or placing the ignition in the OFF position, erases the set speed from memory.

A DAPTIVE C RUISE C ONTROL (ACC) If the button is continually pushed, the set speed will continue to adjust until the button is released, then the new set speed will be estab­ lished. To Accelerate For Passing Adaptive Cruise Control (ACC) increases the driving convenience provided by Cruise Control while traveling on highways and major roadways. However, it is not a safety system and not designed to prevent collisions. The Cruise Control function performs differently Ъ ­page­161. To Resume Speed While the Cruise Control is set, press the accelerator to pass as you would normally. When the pedal is released, the vehicle will return to the set speed.

To resume a previously set speed, push the RES button and release. Resume can be used at any speed above 20­mph (32­km/h). To Deactivate ACC will allow you to keep Cruise Control engaged in light to moderate traffic conditions without the constant need to reset your speed. ACC utilizes a radar sensor and a forward facing camera designed to detect a vehicle directly ahead of you to maintain a set speed. USING CRUISE CONTROL ON HILLS A tap on the brake pedal, pushing the CANC (cancel) button, or normal brake pressure while slowing the vehicle will deactivate the Cruise Control system without erasing the set speed from memory.

The transmission may downshift on hills to maintain the vehicle set speed. NOTE: The Cruise Control system maintains speed up and down hills. A slight speed change on moderate hills is normal. On steep hills, a greater speed loss or gain may occur so it may be preferable to drive without Cruise Control. NOTE: The following conditions will also deactivate the Cruise Control system without erasing the set speed from memory: If the ACC sensor detects a vehicle ahead, ACC will apply limited braking or acceleration (not to exceed the original set speed) automatically to maintain a preset following distance, while matching the speed of the vehicle ahead.

Vehicle parking brake is applied Stability event occurs