166 STARTING AND OPERATING To Resume To Vary The Speed Setting NOTE: When you override and push the SET (+) button or SET (-) buttons, the new set speed will be the current speed of the vehicle. When ACC Is Active: If there is a set speed in memory, push the RES (resume) button and then remove your foot from the accelerator pedal. The instrument cluster display will show the last set speed. To Increase Or Decrease The Set Speed After setting a speed, you can increase the set speed by pushing the SET (+) button, or decrease speed by pushing the SET (-) button. Resume can be used at any speed above 20mph (32km/h) when only Fixed Speed Cruise Control is being used. U.S.
Speed (mph) When you use the SET (-) button to decelerate, if the engine’s braking power does not slow the vehicle sufficiently to reach the set speed, the brake system will automatically slow the vehicle. Resume can be used at any speed above 0mph (0km/h) when ACC is active. Pushing the SET (+), or SET (-) button once will result in a 1mph speed adjustment. Each subsequent tap of the button results in an adjustment of 1mph. The ACC system decelerates the vehicle to a full stop when following the vehicle in front.
If your vehicle follows the vehicle in front to a standstill, after two seconds the driver will either have to push the RES (resume) button, or apply the accelerator pedal to reengage the ACC to the existing set speed. NOTE: If your vehicle is at a standstill for longer than two seconds, then the driver will either have to push the RES (resume) button, or apply the accelerator pedal to reengage the Adaptive Cruise Control (ACC) to the existing set speed. If the button is continually pushed, the set speed will continue to adjust in 5mph incre ments until the button is released. The new set speed is reflected in the instrument cluster display.
Metric Speed (km/h) ACC cannot be resumed if there is a stationary vehicle in front of your vehicle in close proximity. Pushing the SET (+), or SET (-) button once will result in a 1km/h speed adjustment. Each subsequent tap of the button results in an adjustment of 1km/h. The ACC system maintains set speed when driving uphill and downhill. However, a slight speed change on moderate hills is normal. In addition, downshifting may occur while climbing uphill or descending downhill. This is normal operation and necessary to maintain set speed. When driving uphill and downhill, the ACC system will cancel if the braking temperature exceeds normal range (overheated).
WARNING! The Resume function should only be used if traffic and road conditions permit. Resuming a set speed that is too high or too low for prevailing traffic and road conditions could cause the vehicle to accelerate or decelerate too sharply for safe operation. Failure to follow these warnings can result in a collision and death or serious personal injury. If the button is continually pushed, the set speed will continue to adjust in 10km/h incre ments until the button is released. The new set speed is reflected in the instrument cluster display.