RAM 1500 — PARKSENSE FRONT/REAR PARK ASSIST SYSTEM — IF EQUIPPED

172 STARTING AND OPERATING PARKSENSE FRONT/REAR PARK ASSIST SYSTEM — IF EQUIPPED Automatic brakes will not be available if there is a faulted condition detected with the ParkSense Park Assist system or the Braking System. NOTE: The system is provided to assist the driver and not to substitute the driver. The ParkSense Park Assist system provides visual and audible indications of the distance between the rear and/or front fascia/bumper and a detected obstacle when backing up or moving forward (e.g. during a parking maneuver).

If your vehicle is equipped with the automatic braking function, the vehicle brakes may be automatically applied and released when the vehicle is in REVERSE if the system detects a possible collision with an obstacle. The automatic braking function may only be applied if the vehicle deceleration is not enough to avoid colliding with a detected obstacle. The driver must stay in full control of the vehicle's acceleration and braking and is responsible for the vehicle's movements. The automatic braking function may not be applied fast enough for obstacles that move toward the rear of the vehicle from the left and/ or right sides.

For limitations of this system and usage precautions, see Ъ ­page­177. The automatic braking function can be enabled/disabled from the Customer Program­ mable Features section of the Uconnect system. ParkSense will retain the last system state (enabled or disabled) from the last ignition cycle when the ignition is placed in the ON/RUN position. ParkSense can be active only when the gear selector is in REVERSE or DRIVE. If ParkSense is enabled while in one of these gears, the system will remain active until the vehicle speed is increased to approximately 7­mph (11­km/h) or above.

A warning will appear in the instrument cluster display indicating the vehicle speed is above ParkSense operating speed while in REVERSE. The system will become active again if the vehicle speed is decreased to speeds less than approximately 6­mph (9­km/h). NOTE: The driver can disable the automatic braking function by turning ParkSense off via the Park­ Sense switch. The driver can also override auto­ matic braking by changing the gear or by pressing the gas pedal over 90% of its capacity during the braking event. ParkSense will retain its last known configura­ tion state for the automatic braking function through ignition cycles.

Trailer hitch ball assembly may cause false braking events if left attached after towing. Automatic brakes will not be available if the vehicle is in 4WD Low. The automatic braking function is intended to assist the driver in avoiding possible collisions with detected obstacles when backing up in REVERSE gear. Automatic brakes will not be available if there is a fault in the brake module.