RAM 1500 — Parallel/Perpendicular Parking Space Assistance Operation

STARTING AND OPERATING 179 Steering wheel is touched during active steering guidance into the parking space. The ParkSense Active Park Assist switch is acti­ the left side of the steering wheel to change your parking space setting. You can switch between perpendicular and parallel parking maneuvers. ParkSense Front/Rear Park Assist switch is pushed. Driver's door is closed. vated. Driver's door is opened. Tailgate is closed. Tailgate is opened. Vehicle speed is less than 15­mph (25­km/h). The outer surface and the underside of the front and rear fascias/bumpers are clean and clear of snow, ice, mud, dirt or other obstruction.

Electronic Stability Control/Anti-Lock Braking System intervention. Vehicle is in 4WD Low. Axle Locker is active. NOTE: If the vehicle is driven above approximately 15­mph (25­km/h), the instrument cluster display will instruct the driver to slow down. If the vehicle is driven above approximately 18­mph (30­km/h), the system will cancel. The driver must then reac­ tivate the system by pushing the ParkSense Active Park Assist switch. When pushed, the LED on the ParkSense Active Park Assist switch will blink momentarily, and then the LED will turn off if any of the above conditions are not present. P ARALLEL /P ERPENDICULAR P ARKING S PACE A SSISTANCE O PERATION 4 Trailer is connected.

Trailer Reverse Steering Control (TRSC) is active. Press OK to Switch to Perpendicular Park NOTE: The ParkSense Active Park Assist system will allow a maximum of eight shifts between DRIVE and REVERSE. If the maneuver cannot be completed within eight shifts, the system will cancel and the instrument cluster display will instruct the driver to complete the maneuver manually. The ParkSense Active Park Assist system will only operate and search for a parking space when the following conditions are present: Snow plow is connected.

When the ParkSense Active Park Assist system is enabled, the messages “Active ParkSense Searching - Press OK To Switch To Perpendicular Park” or “Active ParkSense Searching - Press OK to Switch to Parallel Park” will appear in the instrument cluster display. Push the OK button on Gear selector is in DRIVE. NOTE: Press OK to Switch to Parallel Park The ignition is in the ON/RUN position. When searching for a parking space, use the turn signal indicator to select which side of the