200 STARTING AND OPERATING Consider the following items when computing the weight on the rear axle of the vehicle: This feature will also allow the driver to back up a vehicle and trailer in a straight line when the knob is rested in its center position. The tongue weight of the trailer. The weight of any other type of cargo or equip ment put in or on your vehicle. Minimal setup is required to use this feature. Set Up: The weight of the driver and all passengers. To use the system, hitch your trailer to the truck and ensure all electrical wiring is connected Ъ page205. NOTE: Remember that everything put into or on the trailer adds to the load on your vehicle.
Also, additional factory-installed options or dealer-installed options must be considered as part of the total load on your vehicle. Refer to the “Tire And Loading Infor mation” placard for the maximum combined weight of occupants and cargo for your vehicle. T RAILER R EVERSE S TEERING C ONTROL The system will automatically calibrate an attached trailer during normal forward driving with no additional action needed from the driver. If the vehicle has not had enough time to automatically calibrate after connecting a trailer, you will see a “Calibrate Trailer” message in the instrument cluster when pressing the TRSC button to activate the system.
If this is the case perform the following maneuver to calibrate the trailer: Trailer Reverse Steering Control Calibration 1 — Straight 100ft (30m) 2 — Intersection turn with radius 50-65ft (15-20m) in either direction 3 — Straight 100ft (30m) 4 — Intersection turn with radius 50-65ft (15-20m) in either direction 5 — Straight 100ft (30m) 6 — Straight 100ft (30m), making sure to align vehicle/trailer to path center line 7 — Feature is active, turn knob left or right to back the trailer up Feature Overview Trailer Reverse Steering Control (TRSC) is a feature that will assist the driver when backing up a trailer.
By turning the knob located on the center stack, you can more accurately control the direction the trailer will go. Drive forward at least 100ft (30m), perform a 90 degree turn and return to a straight position for at least another 100ft (30m). Perform another 90 degree turn, followed by another straight drive of at least 100ft (30m). Check that the system has calibrated by pushing the TRSC button. The driver controls the accelerator and the brake while steering with the use of the Trailer Reverse Steering Control knob. The trailer is steered according to the direction the knob is turned. NOTE: The 90 degree turns could be in either the left or right direction.