RAM 1500 — Trailer Reverse Steering Control

STARTING AND OPERATING 201 Using TRSC trailer to turn left. If you release the knob, it will return to its center position, and the trailer will back up in a straight line. fully, the TRSC activation button is pushed and the vehicle is not in PARK. CAUTION!­ “Trailer Steering ready, shift to reverse” will display when the button is pushed, trailer is cali­ brated and the vehicle is in PARK. Always observe the position of the trailer and surroundings using the camera and mirrors to avoid damage to the truck or trailer. Continue to control the accelerator and brake while backing the trailer up. NOTE:

While active, TRSC will automatically disable Rear Park Assist system if it was previously enabled. The system will limit the top speed your vehicle can travel in REVERSE while using the feature. If needed, you can shift to DRIVE or NEUTRAL to pull forward to get more room or straighten out the trailer, and shift back to REVERSE without the need to reactivate the feature. “Trailer Steering Active” will display after the driver shifts to REVERSE and indicates the feature is active. “Trailer Steering Unavailable” will display if there is a fault in the system preventing activa­ tion, the driver’s door is open, the driver’s seat belt is unbuckled, or the tailgate is open.

4 Other reasons the feature may cancel: The feature will cancel after 30 seconds in DRIVE or when the vehicle speed reaches 8­mph (12­km/h). The driver overrides steering by placing hands on the steering wheel. Trailer tracking is lost. Trailer Reverse Steering Control Knob To cancel out of the feature, come to a stop and shift to PARK, or push the TRSC activation button. If the trailer angle becomes excessive, the brakes apply bringing the vehicle to a stop and then applying the parking brake. To use the system, place the gear selector in PARK and put your foot on the brake. Push the activation button located above the TRSC knob in the center stack.

The LED on the button will glow solid and the instrument cluster display will direct you to shift to REVERSE. Once in REVERSE the system is active. Remove hands from the steering wheel and slowly back up while turning the TRSC knob in the direction you want the trailer to go. Turning the knob clockwise will cause the trailer to turn right. Turning the knob counterclockwise will cause the Instrument Cluster Messages: “Calibrate Trailer ” will display when a trailer is not calibrated and the vehicle is at a standstill while the button is pushed. Trailer steering button is pushed while active. Vehicle speed goes over 8­mph (12­km/h).

“Calibrating Trailer” will display when the trailer is not calibrated and the vehicle is moving while the button is pushed. Driver door is open and seat belt is unbuckled. Transmission shifted to PARK. “To Activate Trailer Steering Shift To P” will display when the trailer is calibrated success­