RAM 1500 — Integrated Trailer Brake Module (ITBM) — If Equipped

204 STARTING AND OPERATING The user interface consists of the following: If no electrical connection is detected after the ignition is turned on, pushing the GAIN adjustment button or sliding the manual brake control lever will display the GAIN setting for 10 seconds and the “Trailer Brake Status Indicator Light” will not be displayed. 4. Push the UP or DOWN button on the steering wheel until “TRAILER TOW” appears on the screen. GAIN Adjustment Buttons (+/-) Pushing these buttons will adjust the brake control power output to the trailer brakes in 0.5­increments. The GAIN setting can be increased to a maximum of 10 or decreased to a minimum of 0 (no trailer braking). 5.

Push the RIGHT arrow on the steering wheel to enter “TRAILER TOW”. If a fault is detected in the trailer wiring or the Integrated Trailer Brake Module (ITBM), the “Trailer Brake Status Indicator Light” will flash. 6. Push the UP or DOWN buttons until the Trailer Brake Type appears on the screen. GAIN 7. Push the RIGHT arrow and then push the UP or DOWN buttons until the proper Trailer Brake Type appears on the screen. The GAIN setting is used to set the trailer brake control for the specific towing condition and should be changed as towing conditions change. Changes to towing conditions include trailer load, vehicle load, road conditions and weather. NOTE:

This should only be performed in a traffic free envi­ ronment at speeds of approximately 20–25­mph (30–40­km/h). 1. Make sure the trailer brakes are in good working condition, functioning normally and properly adjusted. See your trailer dealer if necessary. Adjusting GAIN 8. In a traffic-free environment, tow the trailer on a dry, level surface at a speed of 20–25­mph (30–40­km/h) and squeeze the manual brake control lever completely. Manual Brake Control Lever Slide the manual brake control lever to the left to activate power to the trailer's electric brakes independent of the tow vehicle's brakes.

If the manual brake control lever is activated while the brake is also applied, the greater of the two inputs determines the power sent to the trailer brakes. 9. If the trailer wheels lockup (indicated by squealing tires), reduce the GAIN setting; if the trailer wheels turn freely, increase the GAIN setting. 2. Hook up the trailer and make the electrical connections according to the trailer manufacturer's instructions. Repeat steps 8 and 9 until the GAIN setting is at a point just below trailer wheel lockup. If towing a heavier trailer, trailer wheel lockup may not be attainable even with the maximum GAIN setting of 10.

The trailer and the vehicle’s stop lamps will come on when braking normally with the vehicle brake pedal. Only the trailer stop lamps will come on when the manual brake control lever is applied. 3. When a trailer is plugged in with electric or EOH brakes, the trailer connected message should appear in the instrument cluster display (if the connection is not recognized by the ITBM, braking functions will not be available), the GAIN setting will illuminate and the correct type of trailer must be selected from the instrument cluster display options. Trailer Brake Status Indicator Light This light indicates the trailer electrical connection status.