206 STARTING AND OPERATING 1 — Backup Lamps 2 — Running Lamps 3 — Left Stop/Turn 4 — Ground 5 — Battery 6 — Right Stop/Turn 7 — Electric Brakes During this time the following lights will sequence, each activating for three seconds: 1. Brake and CHMSL (third brake light) 2. Left turn signal 3. Right turn signal 4. Reverse Lamps 5. High Beam Four-Pin Connector This feature will run the trailer lights through a sequence to check the trailer light function. It is available in the Instrument Cluster under the Trailer Tow menu Ъ page108. Trailer Light Check This light check sequence will continue for a total of five minutes.
1 — Ground 2 — Park 3 — Left Stop/Turn 4 — Right Stop/Turn The sequence will only activate if the following conditions are met: When activated the feature will enable all of the exterior lights sequentially for up to five minutes for time to walk around and verify functionality. The following exterior lights will remain on for the entirety of the sequence:
Vehicle is equipped with the Trailer Tow Package Vehicle is in PARK Vehicle is not in motion Ignition in ACC or RUN Park/Running Lamps Remote start is inactive Brakes are not applied Side Marker Lamps (if equipped) License Lamp Left turn signal is not applied Signature Lamp (if equipped) Low Beams Right turn signal not applied Hazard switch is not applied Fog Lamps (if equipped) Seven-Pin Connector Daytime Running Lamps