RAM 1500 — SNOWPLOW

STARTING AND OPERATING 207 The sequence will cancel if any of the following conditions occur: NOTE: Using TOW/HAUL mode or selecting a lower gear range (using the ERS shift control) while operating the vehicle under heavy loading conditions will improve performance and extend transmission life by reducing excessive shifting and heat build up. This action will also provide better engine braking. Tow/Haul Mode SNOWPLOW Brakes are applied Snowplow Prep Packages are available as a factory installed option. These packages include components necessary to equip your vehicle with a snowplow. Vehicle is shifted from PARK Vehicle is no longer stationary Left turn signal activated from stalk NOTE:

Before installation of a snowplow it is highly recom­ mended that the owner/installer obtain and follow the recommendations contained within the current Body Builders Guide. See an authorized dealer, installer or snowplow manufacturer for this infor­ mation. There are unique electrical systems that must be connected to properly ensure operator safety and prevent overloading vehicle systems. Right turn signal is activated from stalk Hazard switch is activated To reduce potential for automatic transmission overheating, activate TOW/HAUL mode when driving in hilly areas, or select a lower gear range (using the (ERS) shift control) on more severe grades.

Cruise Control — If Equipped Any button on the key fob is pushed 4 Ignition button is pushed High Beam stalk position is changed Sequence is canceled in the instrument cluster T OWING T IPS Do not use on hilly terrain or with heavy loads. Before towing, practice turning, stopping, and backing up the trailer in an area located away from heavy traffic. Automatic Transmission When using the Cruise Control, if you experience speed drops greater than 10­mph (16­km/h), disengage until you can get back to cruising speed. WARNING!­ Attaching a snowplow to this vehicle could adversely affect performance of the airbag system in a collision.

Do not expect that the airbag will perform as described earlier in this manual. Use Cruise Control in flat terrain and with light loads to maximize fuel efficiency. Air Suspension System The DRIVE range can be selected when towing. The transmission controls include a drive strategy to avoid frequent shifting when towing. However, if frequent shifting does occur while in DRIVE, select TOW/HAUL mode or select a lower gear range (using the Electronic Range Select (ERS) shift control). To aid in attaching/detaching the trailer from the vehicle, the air suspension system can be used Ъ ­page­150. CAUTION!­ NOTE:

The vehicle must remain in the engine running position while attaching a trailer for proper leveling of the air suspension system. The “Lamp Out” indicator could illuminate if exterior lamps are not properly installed.