RAM 1500 — Shifting Out Of N (Neutral)

STARTING AND OPERATING 211 1. Bring the vehicle to a complete stop on level ground, with the engine running. Apply the parking brake. 9. Shift the transmission to NEUTRAL. Apply the parking brake. Turn off the engine. For vehicles with Keyless Enter ‘n Go™, push and hold the ENGINE START/STOP button until the engine shuts off. The transmission will automatically select PARK when the engine is turned off. ON/RUN mode, the shift will not take place and no position indicator lights will be on or flashing. A flashing N (Neutral) position indicator light indicates that shift requirements have not been met. 2. Press and hold the brake pedal. 3. Shift the transmission to NEUTRAL.

The driver's door must be closed (or the driver's seat belt buckled) so that the transmission will remain in NEUTRAL when the brake pedal is released. 10. Turn the ignition off. If the vehicle is equipped with air suspension, the engine should be started and left running for a minimum of 60 seconds (with all the doors closed) at least once every 24 hours. This process allows the air suspension to adjust the vehicle’s ride height to compensate for temperature effects. Shifting Out Of N (Neutral) 11. Attach the vehicle to the tow vehicle using a suitable tow bar. NOTE: If vehicle is equipped with air suspension, ensure the vehicle is set to Normal Ride Height. 4.

Using a ballpoint pen or similar object, push and hold the recessed transfer case N (Neutral) button (at the center of the transfer case switches). The N (Neutral) indicator light will illuminate, and remain lit, when the shift to N (Neutral) is complete. After the shift is completed and the N (Neutral) light stays on, release the N (Neutral) button. 12. Turn the ignition to the ON/RUN mode, but do not start the engine. 4 13. Release the parking brake. 14. Turn the ignition OFF. Use the following procedure to prepare your vehicle for normal usage: NOTE:

Steps 2 and 3 are requirements that must be met before pushing the N (Neutral) button, and must continue to be met until the shift has been completed. If any of these requirements are not met before pushing the N (Neutral) button or are no longer met during the shift, the N (Neutral) indicator light will flash continuously until all requirements are met or until the N (Neutral) button is released. 1. Bring the vehicle to a complete stop, leaving it connected to the tow vehicle. 2. Press and hold the brake pedal. 5. Release the parking brake. 3. Start the engine. Apply the parking brake. Shift the transmission into NEUTRAL. 6. Shift the transmission into REVERSE. 4.

Using a ballpoint pen or similar object, push and hold the recessed transfer case N (Neutral) button (at the center of the transfer case switches). 7. Release the brake pedal for five seconds and ensure that there is no vehicle movement. 8. Repeat steps 6 and 7 with the transmission in DRIVE. The ignition must be in the ON/RUN mode for a shift to take place and for the position indicator lights to be operable. If the ignition is not in the 5. When the N (Neutral) indicator light turns off, release the N (Neutral) button.