RAM 1500 — Shallow Standing Water

212 STARTING AND OPERATING 6. Turn the engine off. The transmission will automatically select PARK when the engine is turned off. ON/RUN mode, the shift will not take place and no position indicator lights will be on or flashing. D RIVING T HROUGH W ATER A flashing N (Neutral) position indicator light indicates that shift requirements have not been met. DRIVING TIPS Driving through water more than a few inches/ centimeters deep will require extra caution to ensure safety and prevent damage to your vehicle. Flowing/Rising Water 7. Release the brake pedal. 8. Disconnect vehicle from the tow vehicle. 9. Press and hold the brake pedal. 10. Start the engine. 11. Release the parking brake.

D RIVING O N S LIPPERY S URFACES Do not drive on or across a road or path where water is flowing and/or rising (as in storm run-off). Flowing water can wear away the road or path's surface and cause your vehicle to sink into deeper water. Furthermore, flowing and/or rising water can carry your vehicle away swiftly. Failure to follow this warning may result in injuries that are serious or fatal to you, your passengers, and others around you. WARNING!­ 12. Shift the transmission into DRIVE, release the brake pedal, and check that the vehicle operates normally.

Acceleration Rapid acceleration on snow covered, wet, or other slippery surfaces may cause the driving wheels to pull erratically to the right or left. This phenomenon occurs when there is a difference in the surface traction under the rear (driving) wheels. NOTE: Steps 3 and 4 are requirements that must be met before pushing the button to shift out of N (Neutral), and must continue to be met until the shift has been completed. If any of these requirements are not met before pushing the button or are no longer met during the shift, the N (Neutral) indicator light will flash continuously until all requirements are met or until the button is released.

WARNING!­ Rapid acceleration on slippery surfaces is dangerous. Unequal traction can cause sudden pulling of the rear wheels. You could lose control of the vehicle and possibly have a collision. Accelerate slowly and carefully whenever there is likely to be poor traction (ice, snow, wet, mud, loose sand, etc.). Shallow Standing Water Although your vehicle is capable of driving through shallow standing water, consider the following Cautions and Warnings before doing so. The ignition must be in the ON/RUN mode for a shift to take place and for the position indicator lights to be operable. If the ignition is not in the Driving through standing water limits your vehicle’s traction capabilities.

Do not exceed 5­mph (8­km/h) when driving through standing water. WARNING!­ (Continued)