SAFETY 293 Trailer Sway Control (TSC) (automobiles, trucks, motorcycles, etc.) that enter the blind spot zones from the rear/front/side of the vehicle. higher and will alert the driver of vehicles in these areas. TSC uses sensors in the vehicle to recognize an excessively swaying trailer and will take the appropriate actions to attempt to stop the sway. NOTE: NOTE: TSC cannot stop all trailers from swaying. Always use caution when towing a trailer and follow the trailer tongue weight recommendations Ъ page196.
When TSC is functioning, the ESC Activation/ Malfunction Indicator Light will flash, the engine power may be reduced and you may feel the brakes being applied to individual wheels to attempt to stop the trailer from swaying. TSC is disabled when the ESC system is in the “Partial Off” or “Full Off” modes. The BSM system DOES NOT alert the driver about rapidly approaching vehicles that are outside the detection zones. BSM may experience dropouts (blinking on and off) of the side mirror warning indicator lamps when a motorcycle or any small object remains at the side of the vehicle for extended periods of time (more than a couple of seconds).
The vehicle’s taillights, where the radar sensors are located, must remain free of snow, ice, and dirt/road contamination so that the BSM system can function properly. Do not block the taillights with foreign objects (bumper stickers, bicycle racks, etc.). Rear Detection Zones 6 When the vehicle is started, the BSM Warning Light will momentarily illuminate in both outside rearview mirrors to let the driver know that the system is operational. The BSM system sensors operate when the vehicle is in any forward gear and enters standby mode when the vehicle is in PARK.
If TSC activates while driving, slow the vehicle down, stop at the nearest safe location, and adjust the trailer load to eliminate trailer sway. WARNING! AUXILIARY DRIVING SYSTEMS The BSM detection zone covers approximately one lane width on both sides of the vehicle 12ft (3.8m). The zone length starts at the outside rearview mirror and extends approximately 10ft (3m) beyond the rear fascia/bumper of the vehicle.
The BSM system monitors the detection zones on both sides of the vehicle when the vehicle speed reaches approximately 6mph (10km/h) or B LIND S POT M ONITORING (BSM) — I F E QUIPPED BSM uses two radar sensors, located inside the taillights, to detect highway licensable vehicles Radar Sensor Locations