RAM 1500 — Blind Spot Monitoring (BSM) — If Equipped

294 SAFETY If the system detects degraded performance due to contamination or foreign objects, a message will warn you of a blocked sensor and the warning indicators in side view mirrors will be on. The warning indicators will remain illuminated until blockage clearing conditions are met. First clear the taillights around the sensors of the blockage. After removing the blockage, the following procedure can be used to reset the system: Cycle the ignition from ON to OFF and then back ON. Warning Light Location Side Monitoring If the blockage message is still present after cycling the ignition and driving in traffic, check again for a blockage.

The BSM system monitors the detection zone from three different entry points (side, rear, front) while driving to see if an alert is necessary. The BSM system will issue an alert during these types of zone entries. Vehicles that come up from behind your vehicle on either side and enter the rear detection zone with a relative speed of less than 30­mph (48­km/h). Entering From The Rear The system may also detect a blockage if the vehicle is operated in areas with extremely low radar returns such as a desert or parallel to a large elevation drop.

Entering From The Side The BSM system notifies the driver of objects in the detection zones by illuminating the BSM warning light located in the outside mirrors, in addition to sounding an audible (chime) alert and reducing the radio volume Ъ ­page­296. Vehicles that move into your adjacent lanes from either side of the vehicle. Rear Monitoring