SERVICING AND MAINTENANCE 385 function. When performing other underhood services, the hood latch release mechanism, and safety catch should be cleaned and lubricated. The wiper blades and wiper arms should be inspected periodically, not just when wiper performance problems are experienced. This inspection should include the following points: 1. Lift the wiper arm to raise the wiper blade off of the glass, until the wiper arm is in the full up position. The external lock cylinders should be lubricated twice a year, preferably in the Autumn and Spring. Apply a small amount of a high quality lubricant, such as Mopar® Lock Cylinder Lubricant directly into the lock cylinder.
W INDSHIELD W IPER B LADES Wear or uneven edges Foreign material Hardening or cracking Deformation or fatigue Clean the rubber edges of the wiper blades and the windshield periodically with a sponge or soft cloth and a mild nonabrasive cleaner. This will remove accumulations of salt or road film. If a wiper blade or wiper arm is damaged, replace the affected wiper arm or blade with a new unit. Do not attempt to repair a wiper arm or blade that is damaged. Wiper Blade Removal/Installation Operation of the wipers on dry glass for long periods may cause deterioration of the wiper blades. Always use washer fluid when using the wipers to remove salt or dirt from a dry windshield.
Wiper Blade With Release Tab In Locked Position Do not allow the wiper arm to spring back against the glass without the wiper blade in place or the glass may be damaged. CAUTION! 1 — Wiper Blade 2 — Wiper Arm 3 — Release Tab Avoid using the wiper blades to remove frost or ice from the windshield. Keep the blade rubber out of contact with petroleum products such as engine oil, gasoline, etc. 8 NOTE: Life expectancy of wiper blades varies depending on geographical area and frequency of use. If chat tering, marks, water lines or wet spots are present, clean the wiper blades or replace as necessary.