384 SERVICING AND MAINTENANCE A CCESSORY D RIVE B ELT I NSPECTION NOTE: Identify and correct problem before new belt is installed. WARNING! Do not attempt to inspect an accessory drive belt with vehicle running. NOTE: If your vehicle is equipped with a Stop/Start, belt must be replaced with an OEM grade Mopar® belt. Some conditions can be caused by a faulty component such as a belt pulley. Belt pulleys should be carefully inspected for damage and proper alignment. When working near the radiator cooling fan, disconnect the fan motor lead. The fan is temperature controlled and can start at any time regardless of ignition mode. You could be injured by the moving fan blades.
Accessory Belt (Serpentine Belt) Belt replacement on some models requires the use of special tools, we recommend having your vehicle serviced at an authorized dealer. B ODY L UBRICATION You can be badly injured working on or around a motor vehicle. Only do service work for which you have the knowledge and the proper equip ment. If you have any doubt about your ability to perform a service job, take your vehicle to a competent mechanic. Rib chunking (one or more ribs has separated from belt body) Conditions that would require replacement:
Rib or belt wear Longitudinal belt cracking (cracks between two ribs) Locks and all body pivot points, including such items as seat tracks, door hinge pivot points and rollers, liftgate, tailgate, decklid, sliding doors and hood hinges, should be lubricated periodically. Use a lithium-based grease, such as Mopar® Spray White Lube to assure quiet, easy operation and to protect against rust and wear. Prior to the application of any lubricant, the parts concerned should be wiped clean to remove dust and grit; after lubricating excess oil and grease should be removed.
Particular attention should also be given to hood latching components to ensure proper When inspecting accessory drive belts, small cracks that run across the ribbed surface of the belt from rib to rib, are considered normal. This is not a reason to replace the belt. However, cracks running along a rib (not across) are not normal. Any belt with cracks running along a rib must be replaced. Also have the belt replaced if it has excessive wear, frayed cords or severe glazing. Belt slips “Groove jumping" (belt does not maintain correct position on pulley) Belt broken Noise (objectionable squeal, squeak, or rumble is heard or felt while drive belt is in operation)