SERVICING AND MAINTENANCE 389 damage. If any coolant is needed to be added to the system, please contact an authorized dealer. WARNING! additional engine coolant is needed to maintain the proper level, it should be added to the coolant bottle. Do not overfill. Checking Coolant Level — 5.7L Engines Do not use a pressure cap other than the one specified for your vehicle. Personal injury or engine damage may result. Mixing engine coolant types is not recom mended and can result in cooling system damage. If HOAT and OAT coolant are mixed in an emergency, have an authorized dealer drain, flush, and refill with OAT coolant (conforming to MS.90032) as soon as possible.
Cooling System Pressure Cap With the engine off and cold, the level of the engine coolant should be between the ADD and SAFE range on the dipstick. Disposal Of Used Coolant Used ethylene glycol-based coolant (antifreeze) is a regulated substance requiring proper disposal. Check with your local authorities to determine the disposal rules for your community. To prevent ingestion by animals or children, do not store ethylene glycol-based coolant in open containers or allow it to remain in puddles on the ground, clean up any ground spills immediately. If ingested, seek emergency assistance immediately. Checking Coolant Level — 3.6L Engine To check the coolant level:
The cap must be fully tightened to prevent loss of engine coolant (antifreeze), and to ensure that engine coolant will return to the radiator from the coolant expansion bottle/recovery tank (if equipped). 1. Open the coolant reservoir. 2. Lift and remove the plastic dipstick from the reservoir neck. The cap should be inspected and cleaned if there is any accumulation of foreign material on the sealing surfaces. The level of the coolant in the pressurized coolant bottle should be between the “MIN” and “MAX” range on the bottle when the engine is cold. WARNING! 8 Do not open hot engine cooling system. Never add engine coolant (antifreeze) when the engine is overheated.
Do not loosen or remove the cap to cool an overheated engine. Heat causes pressure to build up in the cooling system. To prevent scalding or injury, do not remove the pressure cap while the system is hot or under pressure. The radiator normally remains completely full, so there is no need to remove the cap unless checking for coolant freeze point or replacing engine coolant (antifreeze). Advise your service attendant of this. As long as the engine operating temperature is satisfactory, the coolant bottle need only be checked once a month. When Coolant Reservoir Dipstick 3. Check the coolant level on the dipstick. (Continued)