390 SERVICING AND MAINTENANCE The radiator normally remains completely full, so there is no need to remove the radiator cap unless checking for engine coolant (antifreeze) freeze point or replacing engine coolant. Advise your service attendant of this. As long as the engine operating temperature is satisfactory, the coolant bottle need only be checked once a month. coolant expansion bottle must also be protected against freezing. high temperature. The air is then directed through a hose to the charge air cooler and through another hose to the intake manifold of the engine. This cooling process enables more efficient burning of fuel resulting in fewer emissions.
If frequent engine coolant additions are required, the cooling system should be pressure tested for leaks. Maintain engine coolant concentration at a minimum of 50% OAT coolant (conforming to MS.90032) and distilled water for proper corro sion protection of your engine which contains aluminum components. To guarantee optimum performance of the system, keep the surfaces of the charge air cooler, condenser and radiator clean and free of debris. Periodically check the hoses leading to and from the charge air cooler for cracks or loose clamps resulting in loss of pressure and reduced engine performance.
B RAKE S YSTEM When additional engine coolant is needed to maintain the proper level, it should be added to the coolant bottle. Do not overfill. Cooling System Notes Make sure that the coolant expansion bottle overflow hoses are not kinked or obstructed. NOTE: When the vehicle is stopped after a few miles/kilo meters of operation, you may observe vapor coming from the front of the engine compartment. This is normally a result of moisture from rain, snow, or high humidity accumulating on the radiator and being vaporized when the thermostat opens, allowing hot engine coolant (antifreeze) to enter the radiator.
If an examination of your engine compartment shows no evidence of radiator or hose leaks, the vehicle may be safely driven. The vapor will soon dissipate. Keep the front of the radiator clean. If your vehicle is equipped with air conditioning, keep the front of the condenser clean. In order to ensure brake system performance, all brake system components should be inspected periodically Ъ page364. Do not change the thermostat for Summer or Winter operation. If replacement is ever neces sary, install ONLY the correct type thermostat. Other designs may result in unsatisfactory engine cooling performance, poor gas mileage, and increased emissions.
C HARGE A IR C OOLER — I NTER -C OOLER (D IESEL E NGINE ) WARNING! Riding the brakes can lead to brake failure and possibly a collision. Driving with your foot resting or riding on the brake pedal can result in abnormally high brake temperatures, excessive lining wear, and possible brake damage. You would not have your full braking capacity in an emergency. Do not overfill the coolant expansion bottle. Check the coolant freeze point in the radiator and in the coolant expansion bottle. If engine coolant needs to be added, the contents of the The charge air cooler is positioned in front of the radiator and the air conditioner condenser.
Air enters the engine through the air cleaner and passes through the turbocharger, where it is pressurized. This pressurized air rapidly reaches