SERVICING AND MAINTENANCE 405 Replacing Exterior Bulbs NOTE: It may be necessary to remove/reposition Air Cleaner Assembly to access passenger side headlamp/side marker light bulbs. 4. Disengage the bulb access cover by rotating counterclockwise. High Beam BASE QUAD: LOW BEAM HEADLAMP, HIGH BEAM HEADLAMP, FRONT PARK AND TURN — IF EQUIPPED Low Beam See below steps to replace: 5. Disconnect the internal lamp wiring harness connector from the low beam bulb. 1. Open the hood. 2. Disconnect and isolate the negative battery cable. Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. CAUTION! 3.
Locate the low beam access cover, which can be found on the back side of the headlamps. High Beam Headlight Cover See below steps to replace: 1. Open the hood. Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the bulb socket, or the lamp wiring. 2. Disconnect and isolate the negative battery cable. 3. Locate the high beam access cover, which can be found on the back side of the headlamps. 6. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the lamp. NOTE: It may be necessary to remove/reposition Air Cleaner Assembly to access passenger side headlamp/side marker light bulbs. 4.
Reach behind the headlamp and disengage the access cover by rotating counterclockwise. 8 7. Pull the bulb straight out from the housing. Low Beam Headlight Cover 8. Reverse the procedure for installation of new bulb and covers.