406 SERVICING AND MAINTENANCE 5. Disconnect the internal lamp wiring harness connector from the high beam bulb. 3. Locate the side marker lamp, which can be found on the back side of the headlamps. Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. CAUTION! Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the bulb socket, or the lamp wiring. Park And Turn Socket 4. Reach behind the headlamp and unlock the park and turn socket from the lamp by rotating counterclockwise a quarter turn. Side Marker Lamp 6.
Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the lamp. 5. Pull the bulb straight out from the housing. 4. Disengage the side marker socket by rotating counterclockwise a quarter turn. 7. Pull the bulb straight out from the housing. 6. Separate the bulb from the socket without twisting. 5. Pull the socket and bulb straight out from the housing. 8. Reverse the procedure for installation of new bulb and cover. 7. Reverse the procedure for installation of new bulb and covers. 6. Separate the bulb from the socket without twisting. Front Park And Turn 7. Reverse the procedure for installation of new bulb and covers. See below steps to replace: 1. Open the hood.
Side Marker Lamp See below steps to replace: 2. Disconnect and isolate the negative battery cable. 1. Open the hood. 2. Disconnect and isolate the negative battery cable. 3. Locate the park and turn socket, which can be found on the back side of the headlamps.