RAM 1500 — Rear Tail/Stop, Turn Signal And Backup Lamps

SERVICING AND MAINTENANCE 407 FOG LAMPS — IF EQUIPPED CAUTION!­ 2. Pull the outboard side of the lamp rearward far enough to unsnap the two receptacles on the outboard side of the lamp housing from the two plastic snap post retainers in the outer box side panel. Please see an authorized dealer for service on LED and Halogen front fog lamps. Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result. Halogen See below steps to replace: 1. Reach under and behind the front fascia/ bumper to access the back of the front fog lamp housing.

REAR TAIL/STOP, TURN SIGNAL AND BACKUP LAMPS See below steps to replace: 2. Disconnect the fog lamp wiring harness connector from the fog lamp bulb. 1. Remove the two screws and push pin retainers that pass through the bed sheet metal. Tail Lamp Removal 8 Fog Lamp Bulb 3. Rotate the bulb counterclockwise a quarter turn to unlock the bulb from the housing. Tail Lamp Locations 4. Pull the bulb straight out from the housing. 1 — Tail Lamp 2 — Fasteners 3 — Push - Pin Retainers 5. Reverse the procedure to install the bulb and cover.