46 GETTING TO KNOW YOUR VEHICLE NOTE: Fold the trailer towing mirrors prior to entering an automated car wash. A small blindspot mirror is located next to the main mirror and can be adjusted manually. the vehicle is shifted into REVERSE. The outside mirrors will then return to the original position when the vehicle is shifted out of REVERSE. If the vehicle is equipped with Driver Memory Settings, this feature will be linked to the programmable settings. or home security systems. The HomeLink® unit is powered by your vehicle’s 12 Volt battery. The HomeLink® buttons that are located in the overhead console or sunvisor designate the three different HomeLink® channels. NOTE:
The Tilt Side Mirrors In Reverse feature can be turned on and off using the Uconnect system Ъ page216. UNIVERSAL GARAGE DOOR OPENER (HOMELINK®) — IF EQUIPPED To operate HomeLink®, push and release any of the programmed HomeLink® buttons. These buttons will activate the devices they are programmed to with each press of the corre sponding HomeLink® button. The HomeLink® indicator light is located above the center button Ъ page445.
B EFORE Y OU B EGIN P ROGRAMMING H OME L INK ® Blindspot Mirror For efficient programming and accurate transmission of the radio frequency signal, it is recommended that a new battery be placed in the hand-held transmitter of the device that is being programmed to the HomeLink® system. Make sure your hand-held transmitter is programmed to activate the device you are trying to program your HomeLink® button to. H EATED M IRRORS — I F E QUIPPED These mirrors are heated to melt frost or ice. This feature will be activated whenever you turn on the rear window defroster (if equipped) Ъ page56.
T ILT S IDE M IRRORS I N R EVERSE I F E QUIPPED HomeLink® Buttons Ensure that your vehicle is parked outside of the garage before you begin programming. This feature provides automatic outside mirror positioning which will assist with the driver’s ground visibility. The outside mirrors will move slightly downward from the present position when HomeLink® replaces up to three hand-held transmitters that operate devices such as garage door openers, motorized gates, lighting, It is recommended that you erase all the channels of your HomeLink® before you use it for the first time.