Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

BUCKET Figure PM-53 Bucket Teeth Removal And Installation 1 WARNING Wear safety glasses to prevent eye injury when any of the following conditions exist: Pressurised fluids and springs or other stored energy components. Flying debris or loose material is present. Engine is running. Tools are being used. 2 W-2505-0604 P-23376 Position the bucket so the bucket teeth are at a 30° angle up from the ground for accessibility to the teeth. Remove the two nuts (Item 1) and bolts from the tooth shank (Item 2) [Figure PM-53] . Remove the tooth shank. Lower the boom until the bucket is fully on the ground. Installation: Tighten the nuts to 125 - 135 N•m torque.

Stop the engine and dismount from the excavator. Later Style Bucket Teeth NOTE: The later style tooth points and retaining pins can be used on the early style shanks. Figure PM-54 1 Early Style Bucket Teeth 1 Figure PM-52 2 2 2 1 3 P-69201A The removal and installation procedure for the later style tooth point and tooth shank is the same as the early style. 3 P-23374 The later style tooth has a unique retaining pin (Item 1). The retaining pin must be installed as shown [notch (Item 2) to the front] for proper fit and tooth retention. The side of the tooth point (Item 3) [Figure PM-54] also shows the correct orientation of the retaining pin.

Remove the retaining pin (Item 1) from the tooth point (Item 2) [Figure PM-52] . Remove the tooth point (Item 2) from the shank (Item 3) [Figure PM-52] . Installation: Position the new tooth point on the shank and install a new retaining pin. Install the retaining pin until it is flush with the top of the point. Installation: Position the new tooth point on the shank and install a new retaining pin. Install the retaining pin until it is flush with the top of the point. 325/328 Excavator Operation and Maintenance Manual 86