LUBRICATION OF THE HYDRAULIC EXCAVATOR Figure PM-56 Procedure Lubricate the hydraulic excavator as specified in the SERVICE SCHEDULE for the best performance of the machine. (See SERVICE SCHEDULE on Page 59.) 5 6 7 Always use a good quality lithium based multipurpose grease when lubricating the machine. Apply the lubricant until extra grease shows. 6 6 Lubricate the following locations on the Hydraulic Excavator EVERY 8-10 HOURS: 8 Figure PM-55 5 P-49452 4 5. Boom Swing Pin (2) [Figure PM-56] 6. Boom Swing Pivot (3) [Figure PM-56] 7. Boom Pivot (1) [Figure PM-56] 8. Boom Cylinder Base End (1) [Figure PM-56] 3 1 Figure PM-57 3 2 10 P-49451 Ref Description (# of Fittings) 1.
Blade Cylinder Rod End (1) [Figure PM-55] 2. Blade Cylinder Base End (1) [Figure PM-55] 3. Blade Pivots (2) [Figure PM-55] 9 4. Boom Swing Cylinder Rod End (1) [Figure PM-55] P-42463 9. Boom Cylinder Rod End (1) [Figure PM-57] 10. Arm Cylinder Base End (1) [Figure PM-57] 325/328 Excavator 87 Operation and Maintenance Manual