Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

ATTACHMENTS (CONT’D) Figure OI-72 Using The X-Change System (Cont’d) Installing Bucket Or Attachment (Bolt-On X-Change) Use the bolt-on X-Change components when installing older attachments that do not have the pin retention provision. Bolt-on components are supplied with the excavator and are stored under the right side cover. 1 1 1 NOTE: Removal and installation of the bucket is shown. The procedure is the same for other attachments. Disconnect any hydraulic lines that are operated by hydraulic power before removing any attachments (breaker, auger, etc.). P-49714 Remove the three plugs (Item 1) [Figure OI-72] .

WARNING Figure OI-73 Never use attachments or buckets which are not approved by Bobcat Company. Buckets and attachments for safe loads of specified densities are approved for each model. Unapproved attachments can cause injury or death. W-2052-0500 1 1 Figure OI-71 P-49715 Apply grease to the O-rings (Item 1) [Figure OI-73] . P-49713 Fully retract the bucket cylinder and lower the arm to the ground [Figure OI-71] . With the engine off, turn the start key to the ON position and move both hydraulic control levers to relieve hydraulic pressure. 325/328 Excavator Operation and Maintenance Manual 32