ATTACHMENTS (CONT’D) Remove the two bolts (Item 1) and plate (Item 2) [Figure OI-81] . Using The X-Change System (Cont’d) Removing Bucket Or Attachment (Bolt On X-Change) Figure OI-82 Figure OI-80 2 1 P-49835 P-49838 Start the engine, raise the boom approximately 300 mm and extend the bucket cylinder until the X-Change pins (Item 1) engage the hooks (Item 2) [Figure OI-82] on the bucket. Park the Excavator on a flat, level surface. Put the bucket on the ground [Figure OI-80] . With the engine off, turn the start key to the ON position and move both hydraulic control levers to relieve hydraulic pressure. Figure OI-81 1 2 1 P-49719 325/328 Excavator Operation and Maintenance Manual 36