ATTACHMENTS (CONT’D) Using The X-Change System (Cont’d) Installing Bucket Or Attachment (Bolt On X-Change) (Cont’d) Figure OI-79 1 1 P-49719 Install the bolts (Item 1) [Figure OI-79] through the plate and into the X-Change. Tighten the bolts to 177 N•m torque. Re-torque the bolts after every eight hours of operation. Check for proper installation. Lift the attachment and fully extend and retract the bucket cylinder. WARNING Keep all onlookers 6 m away from equipment when operating. Contact with moving parts, a trench collapse or flying objects can cause injury or death. W-2119-0788 325/328 Excavator 35 Operation and Maintenance Manual