OPERATING PROCEDURE (CONT’D) Figure OI-114 Operating On Slopes (Cont’d) Forward Figure OI-113 1 Reverse P-49125 To brake the machine when going down a slope, move the steering columns (Item 1) [Figure OI-114] to the NEUTRAL position. This will engage the hydrostatic braking. When operating on a slope, level the work area before beginning [Figure OI-113] . When the engine stops on a slope, move the steering columns to the neutral position. Lower the boom/bucket to the ground. If this is not possible, the following procedures should be used: Do not work on slopes which exceed 15 degrees. NOTE:
If the engine stops, the boom/bucket (attachments) can be lowered to the ground using hydraulic pressure which is stored in the accumulator. Work slowly. Avoid working with the tracks across the slope, which reduces stability and increase the tendency for the machine to slide. Position the excavator with the blade downhill and lowered. The console must be in the locked down position, and the key switch in the ON position. Use the control lever to lower the boom. Avoid swinging or extending the bucket more than necessary in a down hill direction. When it is necessary to swing the bucket downhill, keep the arm low and skid the bucket downhill. Start the engine and resume operation.
When working with the bucket on the uphill side, keep the bucket as close to the ground as possible. Dump the spoil far enough away from the trench or hole to prevent the possibility of a collapse. 325/328 Excavator 49 Operation and Maintenance Manual Neu tral Recommended Position For Working On A Slope B-19935