Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

Engage the slew lock. Move the machine forwards onto the transportation vehicle [Figure OI-119] . WARNING Adequately designed ramps of sufficient strength are needed to support the weight of the machine when loading onto a transportation vehicle. Wooden ramps can break and cause personal injury. Do not change direction of the machine while it is on the ramps. Lower the boom, arm, bucket, and blade to the transportation vehicle. W-2058-0494 Stop the engine and remove the key (if equipped). Put blocks at the front and rear of the tracks.

325/328 Excavator Operation and Maintenance Manual 52 TRANSPORTING THE EXCAVATOR Figure OI-120 Procedure When transporting the machine, observe the rules, motor vehicle laws, and vehicle limit ordinances. Use a transportation and towing vehicle of adequate length and capacity. 1 Apply the hand brake and block the wheels of the transportation vehicle. 1 Align the ramps with the centre of the transportation vehicle. Secure the ramps to the truck bed and be sure ramp angle does not exceed 15 degrees. P19508 Use metal loading ramps with a slip resistant surface. Use ramps that are the correct length and width and can Figure OI-121 support the weight of the machine.

The rear of the trailer must be blocked or supported when loading or unloading the excavator to prevent the front of the transportation vehicle from rising up. 1 Determine the direction of the track movement before moving the machine (blade forwards). Figure OI-119 P-49459 Attach chains to the front corners of the blade (Item 1) [Figure OI-120] and to the tie down loop at the rear of the track frame (Item 1) [Figure OI-121] to prevent it from moving when going up or down slopes or during sudden stops. Use chain binders to tighten the chains and then safely tie the chain binder levers to prevent loosening. P-49458 P-49458 P-49458