AIR CLEANER (CONT’D) Inner Filter Replacing The Filters (Cont’d) Only replace the inner filter under the following conditions: Figure PM-6 Replace the inner filter every third time the outer filter is replaced. After the outer filter has been replaced, press the button (Item 3) [Figure PM-7] on the top of the condition indicator and start the engine. Run at full RPM, then reduce engine speed and stop the engine. If the red ring shows in the condition indicator, replace the inner filter. 1 Figure PM-8 P-49414 1 Pull the outer filter (Item 1) [Figure PM-6] from the air cleaner housing. Check the housing for damage. Clean the housing and the seal surface. DO NOT use compressed air.
P-49413 Install a new filter. Figure PM-7 Remove the dust cup, outer filter and inner filter (Item 1) [Figure PM-8] . 3 NOTE: Make sure all sealing surfaces are free of dirt and debris. 1 Install the new inner filter. Install the outer filter and the dust cup. Press the button on the condition indicator to remove the red ring. 2 P-49412 Install the dust cup (Item 1) and engage the fasteners (Item 2) [Figure PM-7] . Check the air intake hose and the air cleaner housing for damage. Make sure all connections are tight. 325/328 Excavator 63 Operation and Maintenance Manual