SEAT BELT Figure PM-9 Inspection And Maintenance WARNING Failure to properly inspect and maintain the seat belt can cause lack of operator restraint resulting in serious injury or death. W-2466-0703 Check the seat belt daily for correct function. Inspect the seat belt system thoroughly yearly or more often if the machine is exposed to severe environmental conditions or applications. The seat belt system should be repaired or replaced if it shows cuts, fraying, extreme or unusual wear, significant discolourations due to ultraviolet (UV) rays from the sun, dusty/dirty conditions, abrasion to the seat belt webbing, or damage to the buckle, latch plate, retractor (if equipped), or hardware.
B-22283 The items below are referenced in [Figure PM-9] . 1. Check the seat belt webbing. If the system is equipped with a retractor, pull the webbing completely out and inspect the full length of the webbing. Check for cuts, wear, fraying, dirt and stiffness. 2. Check the buckle and latch for proper function. Make sure latch plate is not excessively worn, deformed or buckle is not damaged. 3. Check the retractor web storage device (if equipped) by extending the seat belt webbing to determine if it extends and retracts the webbing correctly. 4. Check webbing in areas exposed to ultraviolet (UV) rays from the sun or extreme dust or dirt.
If the original colour of the webbing in these areas is extremely faded and / or the webbing is packed with dirt, the webbing strength may have weakened. See your Bobcat dealer for approved seat belt system replacement parts for your machine. 325/328 Excavator Operation and Maintenance Manual 64