Bobcat 325/328 Excavator — 6902610-325-328 om 3-06(8).book

COOLING SYSTEM (CONT’D) Figure PM-28 Replacing The Coolant 1 See the SERVICE SCHEDULE for correct service intervals. (See SERVICE SCHEDULE on Page 59.) WARNING AVOID BURNS Do not remove radiator cap when the engine is hot. You can be seriously burned. W-2070-1203 P19225 Figure PM-26 Connect a hose to the drain valve on the engine block. Open the drain valve (Item 1) [Figure PM-28] . Drain the coolant into a container. After all the coolant is removed, close the drain valve. 1 Recycle or dispose of the used coolant in an environmentally safe manner. Mix the coolant in a separate container. See SPECIFICATIONS for correct capacity. NOTE:

The cooling system is factory filled with propylene glycol (purple colour). DO NOT mix propylene glycol with ethylene glycol. P-49424 Add premixed coolant; 47% water and 53% propylene glycol to the recovery tank if the coolant level is low. When the engine is cool, loosen and remove the radiator cap (Item 1) [Figure PM-26] . 4.3 litres of propylene glycol mixed with 3.8 litres of water is the correct mixture of coolant to provide a -37 ° C freeze protection. (See Checking Coolant Level on Page 72.). Figure PM-27 Use a refractometer to check the condition of propylene glycol in your cooling system. Add premixed coolant until the level is correct.

Run the engine until it is at operating temperature. Stop the engine. Check the coolant level and add as needed. Be sure the radiator cap is tight. Add coolant to the recovery tank as needed. 1 Close the right side cover. P-49426 Connect a hose to the drain valve at the bottom of the radiator. Open the drain valve (Item 1) [Figure PM-27] and drain the coolant into a container. 325/328 Excavator 73 Operation and Maintenance Manual