ELECTRICAL SYSTEM Fuse And Relay Location Description A sticker is inside the cover to show location and amp ratings. Figure PM-29 Remove the cover to check or replace the fuses and relays. Figure PM-30 1 P-49427 The Excavator has a 12 volt, negative ground electrical system. The electrical system is protected by fuses located under the right side cover of the Excavator (Item 1) [Figure PM-29] . The fuses will protect the electrical system when there is an electrical overload. The reason for the overload must be found before starting the engine again. B-19812 The location and sizes are shown below and [Figure PM-30] . The battery cables must be clean and tight.
Check the electrolyte level in the battery. Add distilled water as needed. Remove acid or corrosion from the battery and cables with a sodium bicarbonate and water solution. Put Battery Saver P/N 6664458 or grease on the battery terminals and cable ends to prevent corrosion. WARNING Always replace fuses using the same type and capacity. Batteries contain acid which burns eyes and skin on contact. Wear goggles, protective clothing and rubber gloves to keep acid off body. In case of acid contact, wash immediately with water. In case of eye contact get prompt medical attention and wash eye with clean, cool water for at least 15 minutes.
If electrolyte is taken internally drink large quantities of water or milk! DO NOT induce vomiting. Get prompt medical attention. W-2065-1296 325/328 Excavator Operation and Maintenance Manual 74 REF DESCRIPTION AMP REF DESCRIPTION AMP 1 Not Used - - 11 Lights 20 2 Heater 25 12 ACC Plug 15 3 Ignition 5 4 Fuel Solenoid 25 5 Wiper 5 6 Switch Power 20 7 Alternator/Heater 25 8 ACD 25 9 Controller 25 10 ACD 25 REF DESCRIPTION E Switch Power F Fuel Solenoid G Lights H Glow Plug J Starter