ELECTRICAL SYSTEM (CONT’D) Using A Booster Battery (Jump Starting) WARNING IMPORTANT Batteries contain acid which burns eyes and skin on contact. Wear goggles, protective clothing and rubber gloves to keep acid off body. If jump starting the excavator from a second machine: In case of acid contact, wash immediately with water. In case of eye contact get prompt medical attention and wash eye with clean, cool water for at least 15 minutes. When jump starting the excavator from a battery installed in a second machine is NOT running while using the glow plugs. High voltage spikes from a running machine can burn out the glow plugs.
If electrolyte is taken internally drink large quantities of water or milk! DO NOT induce vomiting. Get prompt medical attention. I-2060-0195 If it is necessary to use a booster battery to start the engine, BE CAREFUL! There must be one person in the operator’s seat and one person to connect and disconnect the battery cables. W-2065-1296 WARNING Be sure the key switch is OFF. The booster battery must be 12 volt. Keep arcs, sparks flames and lighted tobacco away from batteries. When jumping from booster battery make final connection (negative) at machine frame. Open the tailgate. Figure PM-31 Do not jump start or charge a frozen or damaged battery.
Warm battery to 16°C before connecting to a charger. Unplug charger before connecting or disconnecting cables to battery. Never lean over battery while boosting, testing or charging. Battery gas can explode and cause serious injury. 1 W-2066-0705 IMPORTANT 2 P-49428 Damage to the alternator can occur if: Engine is operated with battery cables disconnected. Battery cables are connected when using a fast charger or when welding on the excavator. (Remove both cables from the battery.) Extra battery cables (booster cables) are connected incorrectly. Connect one end of the first cable to the positive (+) terminal of the booster battery.
Connect the other end of the same cable to the positive (+) terminal (Item 1) [Figure PM-31] of the excavator starter. Connect one end of the second cable to the negative (-) terminal of the booster battery. Connect the other end of the same cable to the negative excavator cable (Item 2) [Figure PM-31] where it is attached to the frame. I-2222-0903 NOTE: (See Cold Temperature Starting Procedure on Page 24.) Start the engine. After the engine has started, remove the ground (-) cable first (Item 2) [Figure PM-31] . Disconnect the cable from the excavator starter (Item 1) [Figure PM-31] . 325/328 Excavator 75 Operation and Maintenance Manual