Cummins — Cummins CM2220 R2.8 Installation Guide R101B

Electrical System R2.8 CM2220 R101B Page 1-48 Section 1 - Installation by Subsystem 1 16 Pin Data Link Onboard Diagnostics Connector 2 Accelerator Pedal Should the user choose not to install the J1939 cab display (with integrated warning and stop engine lights) it is strongly recommended to install and connect to the ECM three engine indicator lamps to properly communicate the engine state to the driver. The cab-side harness provides four lamps to alert the driver to the condition of the engine.

Red, STOP Lamp 3 23 Pin Bulkhead (Deutsch) Connector If the driver receives a STOP lamp indication, the driver should cease operation of the vehicle and engine as quickly as possible to reduce damage to the engine or associated systems. This lamp is required. Yellow, WARNING Lamp If the driver receives a WARNING lamp indication for a maintenance or service condition, the driver should have the condition corrected as soon as convenient. This lamp is required. White, WAIT-TO-START Lamp The WAIT-TO-START Lamp indicates the driver has turned the keyswitch to an engine run position, but should wait to start the vehicle.

The most common reason for this is to wait for the intake air heaters to complete a preheat cycle during cold ambient conditions. This lamp is required. MIL Lamp The MIL lamp displays messages which require prompt operator attention and diagnostics messages. If the driver receives a MIL lamp indication for an emissions fault, the driver should take the vehicle to a service center as soon as possible. The MIL lamp color can not be red, and the lettering is to comply with International Organization for Standardization (ISO) 2575 number F01 or F22. This lamp is not used on the R2.8 CM2220 R101B product. NOTE:

For proper operation of the warning lights, the installer needs to provide positive battery connection to the light, and connect another side to the labeled lead of the harness. The ECM will enable a grounding path for the warning light to illuminate. NOTE: The ECM supports the use of LED or incandescent indicator lamps. There is a small leakage current through the lamp driver circuit that can cause some LEDs to appear to be ON when they are actually OFF. The LED illumination should be verified. If appropriate, a resistor should be wired in parallel with the LED to prevent the LED appearing ON when actually OFF. A resistor on the order of 4.0-7.0 k ohms should be sufficient.

Verify this value for your application. The J1939 cab display also reads engine speed. If the user chooses to integrate the factory tachometer, the R2.8 CM2220 R101B wiring harness includes a tachometer output signal wire. The signal wire (white wire, labeled Tach, pin 9) exists in one of two states, source or sink. The ECM toggles the state rapidly to produce a square wave with a variable frequency and a fixed nominal duty cycle of 50 percent. Four pulses are produced for each crankshaft revolution, for an output frequency (Hz), per the following formula:

Engine rpm x 4 pulses per revolution x 1 minute per 60 seconds There is a minimum allowable frequency for the square-wave, which corresponds to a lower threshold of the engine speed which can be reported to the tachometer. The ECM provides a single pin output interface for the tachometer output with the following requirements in the table below.

To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com General Lamp Information Item Requirement Standard Society of Automotive Engineers (SAE) Recommended Practice J1211 Type Incandescent or Light-Emitting Diode (LED) Typical Voltage 12 VDC Minimum Luminosity 2 Candle Power 2 Candle Power 500 mA Steady State Item Requirement Operational States Two: SOURCE and SINK Modes One: pulse width modulation (PWM) Minimum Source Voltage (@Maximum Source Current) 6.0 volts