R2.8 CM2220 R101B Starting the Engine Section 2 - Start-Up and Troubleshooting Page 2-1 Starting the Engine (389-001) General Information WARNING Improper practices, carelessness, or ignoring the warnings can cause burns, cuts, mutilation, asphyxiation, or other personal injury or death. The cooling fan will engage when the engine is started. To prevent serious personal injury, keep your hands clear of the fan’s path when starting the engine and during engine operation. WARNING Do not mix gasoline, alcohol, or gasohol with diesel fuel. This mixture can result in a fire or explosion. WARNING WARNING Depending on the circumstance, diesel fuel is flammable.
When inspecting or performing service or repairs on the fuel system, to reduce the possibility of fire and resulting severe personal injury, death, or property damage, never smoke or allow sparks or flames (such as pilot lights, electrical switches, or welding equipment) in the work area. Before attempting to start the engine for the first time, review the installation, paying special attention to safety issues that may occur during the initial engine starting. Read this procedure entirely before starting the engine. Electrical WARNING Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries.
To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. Do not overtighten the electrical connections. Starter damage can result. CAUTION Install the cables and tighten the battery connections. Coat the terminals with grease to prevent corrosion. Figure 1 - Install Battery Connection Fluids Lubricating Oil Check the lubricating oil drain plug to make sure it is tight. Torque Value: 24 N•m [ 212 in-lb ] To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com