Cummins — Cummins CM2220 R2.8 Installation Guide R101B

Starting the Engine R2.8 CM2220 R101B Page 2-6 Section 2 - Start-Up and Troubleshooting Figure 10 - Idle Engine for 3 to 5 Minutes WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [122°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. Bring the engine back to idle for 3 to 5 minutes, allowing the engine to cool down and proceed to shut the engine off. Check the fluid level as done before start up. Monitor Service and Troubleshooting Information Cummins® QuickServe® Online (QSOL) web site is available for service and troubleshooting information. NOTE: The link to QSOL is:

https://quickserve.cummins.com/info/index.html Figure 11 - Register for Cummins® QuickServe® Online You will need to create an account to utilize the website as shown above. Once your account is active and you log in, you will use the engine serial number (ESN) of your R2.8 CM2220 R101B engine to gain access to the available information. The ESN is noted on the engine data tag affixed to the top of the valve cover. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com