Cummins — Cummins CM2220 R2.8 Installation Guide R101B

Lubricating Oil System R2.8 CM2220 R101B Page 1-22 Section 1 - Installation by Subsystem Oil filter differential pressure to open bypass........................................................................ 310 to 379 kPa [45 to 55 psi] Lubricating Oil Filter Capacity........................................................................................................... 0.436 liters [0.461 qt] Oil Capacity:

Oil change with filter change..............................................................................................................5.4 liters [5.74 qt] Oil change without filter change.........................................................................................................5.0 liters [5.28 qt] High to Low (on dipstick)........................................................................................................................ 1 liter [1.06 qt] Maximum Oil Temperature:..........................................................................................................................

136°C [275°F] General Information A remote, off-engine, full flow lubricating oil filter is used on this engine. NOTE: The lubricating oil filter is temporarily mounted on the engine flywheel housing with the bracket for shipping purposes only . The lubricating oil filter should be mounted on the chassis vertically for the proper operation and ease of service. Refer to Procedure 018-024 in Section V for lubricating oil filter part numbers. Figures 1 and 2 provide the dimensions to design and build a suitable chassis-mounted, vertical lubricating oil filter mounting bracket. The hoses provided with the remote lubricating oil filter system should be used to maintain cleanliness of the system.

1 Mounting holes, front-to-rear centerline to rear mounting holes 42 mm [1.6 in] Figure 1 - Lubricating Oil Filter Head Top View 2 Mounting hole width, front-to-rear - 83 mm [3.27 in] 3 Mounting hole size - M8 x 1.25-6H, 17 mm [0.7 in] deep, four places 4 Mounting hole width, side-to-side - 60 mm [2.36 in] 5 Mounting hole width, side-to-side centerline to front mounting holes - 30 mm [1.2 in] 6 Front lubricating oil hose fitting, M26 x 1.5-6g, 12 degrees inverted flare, both ends 7 Rear lubricating oil hose fitting, 7/8-14 UNF - 2A, 37 degrees flare, both ends. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com