Cummins — Cummins CM2220 R2.8 Installation Guide R101B

R2.8 CM2220 R101B Lubricating Oil System Section 1 - Installation by Subsystem Page 1-21 A connection is located at the back of the engine for reduced pressure coolant returning from the heater core. See Figure 6 above. Cab Heater Return Connection Figure 6 - Coolant Return from Heater Core Outside Diameter: 16 mm [0.6 in] Clamping Distance: 32 mm [1.3 in] from the end Auxiliary Coolant Sensor Location Should an auxiliary coolant temperature sensor be required for an accessory device or dash gage, there is a port on the engine that can be used. This sensor is customer-supplied. An M12 port (1) is shown below in Figure 7, located between the coolant outlet and the FEAD idler pulley.

Figure 7 - Auxiliary Coolant Sensor Location NOTE: The housing is non-conductive, thus a single pole sensor switch will require an additional ground wire to be installed. Lubricating Oil System (391-003) Specifications Oil Pressure: Low idle (minimum allowed).................................................................................................................. 69 kPa [10 psi] At rated (minimum allowed).................................................................................................................321 kPa [47 psi] Oil-regulating valve-opening pressure range........................................................................

350 to 360 kPa [51 to 52 psi] To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com