R2.8 CM2220 R101B Air Intake System Section 1 - Installation by Subsystem Page 1-27 Figure 4 - Poor Radiator and CAC Design The CAC tanks block the radiator core area. Very little air is flowing to the blocked area of the radiator core. Much of the radiator core area receives heated ambient air from the CAC. Air Flow Improvements The air flow through the heat exchanges can be increased by changes to the following: Reduce the obstructions in the path of the ambient air flow through the CAC and radiator. The entering cooling ambient air must be directed through the CAC and radiator.
Baffling that surrounds the CAC and radiator can be very effective in funneling the air through the CAC and radiator. The goal is to get the cooling ambient air to flow where you want it, and not get mixed with hot engine compartment air before it enters the CAC and radiator. Once the heated ambient cooling air has passed through the CAC and radiator, it must have an easy path to exit the engine compartment. Any blockage or restrictions to the air flow will diminish the ability to get air to flow through the CAC and radiator. Vents located on the hinged end of a hood, or prescribed gaps at the hood windshield interface, are effective in reducing the under hood restriction.
Improve the fan drive shrouding. The fan shroud should cover the entire radiator core area. This forces the ambient air to pass through the CAC and radiator. The fan should be located about three inches behind the radiator core to promote uniform air flow distribution. See Figure 5 and Figure 6. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com